Motorised Magstripe/IC Card Dispenser/Reader/writer

Ⅰ. Introduction -This specification provides the transmission specifications between the BAT930 Series Card Issuing Machine and the host terminal. -The BAT930 is a motorized Card Issuing Machine handling magnetic stripe card, IC card in accordance with ISO 7811/7816 and memory IC card including SLE4442/SLE4418/SLE4428,AT24C01, AT24C02, AT24C04, AT24C08, AT24C16, AT24C32, AT24C64 and RF card accordance with ISO 14443. Ⅱ. Outlines about Device 􀁺 This device consists of a Card Reader/Writer and Dispenser Unit which is attached rear of Card Reader/Writer, as well as a case. 􀁺 The interface with host is controlled by commands and responses via RS232 line. 􀁺 Outline of Function - Reads/writes a magnetic card that was fed from the Card Dispenser. - Reads/writes a (magnetic, IC or both) card that was inserted from front. - Ejects to front or captures a card that was read/written. Ⅲ. References Standards The following standards contain provisions that are referred in this specification. ISO/IEC 7816-3:1997 Identification cards – Integrated circuit(s) cards with contacts Part 3: Electronic signals and transmission protocols ISO/IEC 7816-4:1995 Identification cards – Integrated circuit(s) cards with contacts Part 4: Inter-industry commands for interchange ISO/IEC 7810: 1995-08-15 Identification cards – Physical characteristics ISO/IEC 7811-1: 1995-08-15 Identification cards – Recording technique Part 1:Embossing ISO/IEC 7811-2: 2001-02-01 Identification cards – Recording technique Part 2:Magnetic stripe – Low coercivity ISO/IEC 7811-3: 1995-08-15 Identification cards – Recording technique Part 3:Location of embossed characters on ID-1 cards ISO/IEC 7811-4: 1995-08-15 Identification cards – Recording technique Part 4:Location of read-only magnetic tracks – Tracks 1 and 2 ISO/IEC 7811-5: 1995-08-15 Identification cards – Recording technique Part 5:Location of read-only magnetic tracks – Tracks 3 ISO/IEC 7811-6: 2001-02-01 Identification cards – Recording technique Part 6:Magnetic stripe – High coercivity ISO 2111: 1985-02-01 Data communication – Basic mode control procedures -Code independent information transfer EMV 3.1.1: May 31 1998 EMV ’96 Integrated Circuit Card Specification for Payment Systems Part I – Electromechanical Characteristics, Logical Interface, and Transmission Protocols Memory Card SIEMENS SLE4432/SLE4442 Data Books SIEMENS SLE4418/SLE4428Data Books ATMEL 24CXX Data Books