Telescopic Flap Door Module

1. Product Introduction The system consists of a gate control board, a brushless servo motor, servo control technology, real-time detection of the motor position, no external encoder, self-learning load curve, physical anti-pinch protection, adjustable sensitivity; support entrance and exit card swiping, free, Prohibition of passage mode settings; with illegal intrusion, trailing passage, detention, reverse passage, infrared anti-pinch and other passage logic detection, suitable for speed gate/swing gate, flap gate/sliding gate and other access gate equipment。 1.1. Features Brushless servo solution Ordinary brushless solution Adapted motor Brushless motor with 2400 line position feedback Ordinary brushless motor Anti-pinch protection Current + position double detection, adjustable sensitivity No encoder, low anti-pinch sensitivity Control effect Fast opening and closing speed, stable without shaking Deceleration is obvious and shaking 1.2. Technical Parameters  Input power：DC24V，Recommended unilateral 150W / 6.5A；  Adapted motor：Brushless DC motor below 60w with 2400 line position feedback;  Communication method：RS232 serial communication, support Modbus protocol；  Switch off the power：DC12V battery, or optional super capacitor module；  Working environment：-20℃ ~ 55℃，Humidity below 90% (no condensation)  Infrared sensor: 6 independent interfaces, PNP, NPN normally open, open collector type；  Voice output: external 8W 4Ω speaker. 1.3. Normally open and fire-control function  Normally open mode：Long press the card swiping button for 5S or continuously connect the swiping signal port GND 5S, the gate will enter the normally open mode (5S for the LO signal is the normally open mode in the enter direction, and the RO signal 5S is the normally open mode in the exit direction). At this time, the gate is opened (infrared judgment is invalid), the light shows a green light, and the buzzer and horn have no output. The signal is cancelled, the gate is closed, and the previous state is restored.  Fire-control mode：When the auxiliary port Fire is connected to GND, the gate will enter the fire-control mode. At this time, the gate is opened (infrared judgment is invalid), the light shows a green light, the buzzer sounds, and the voice broadcast "fire alarm, please evacuate quickly". The signal is cancelled, the gate is closed, and the previous state is restored.